ADSS Cable Anchor with Wedge Grip PA-54-01500
The PA-54-01500 tension clamp anchors ADSS cables during telecommunications line construction.
Features
- Suitable for FTTx cable installations
- Self-adjusting wedge grip protects the messenger
- Cast aluminum-alloy body, stainless steel bail and UV-resistant wedges
- Minimum breaking load: 8 kN
- Stable performance in outdoor conditions
- Economically priced
Application
The PA-54-01500 clamp secures and protects outdoor optical cables on telecommunications supports. It is used on routes between buildings and industrial structures as part of aerial FTTx installations.
The self-adjusting wedge retains the messenger while protecting it from damage. A cast aluminum alloy body, stainless steel bail and UV-resistant wedges provide durability and environmental resistance. This variant accommodates 8–12 mm cable and an 8 kN minimum breaking load.
| Product code | Cable diameter, mm | MBL, kN |
| PA-54-01500 | 8-12 | 8.0 |
Ultimate tensile strength testing evaluates a product’s capacity to withstand mechanical pulling loads. Opposing tensile forces are applied to a specimen until it deforms or fails. The resulting measurements provide information on elongation, yield point, tensile strength and ultimate strength.
JKTE uses tensile testing for pole-line suspension clamps, preformed guy grips, ADSS dead-end fittings, stainless steel bands, FTTH drop clamps and tension clamps.
For overhead optical cables and their accessories, endurance testing combines mechanical and thermal loading with oscillating stresses. The applicable test values depend on the requirements of IEC 61284.
These standard-based tests are applied before new products are released and during routine production to check conformity with quality requirements. JKTE’s in-house laboratory carries out the relevant series of type tests.
Application
